Concorde V6-3.2L VIN J (2000)
NOTE: The 2 wheel nuts must be installed on the studs shown to allow the installation of the wheel cover.
1. Align the valve notch in the wheel cover with the valve stem on the wheel. Align the two holes in the wheel cover having the retaining tabs, with
the two installed and properly tightened wheel nuts.
2. Press in on center of wheel cover until retaining tabs on wheel cover engage with wheel nuts. This will hold the wheel cover to the wheel.
3. Install the three remaining wheel nuts.
4. Tighten all 5 wheel nuts to a torque of 135 Nm (100 ft. lbs.).