Concorde V6-3.2L VIN J (2000)
Fig. 11
CAUTION: When removing outer ON joint from hub and bearing assembly, do not allow the flinger disk (Fig. 11) on hub and bearing assembly
to become damaged. Damage to the flinger disk will cause dirt and water intrusion into bearing. Premature bearing failure will result.
12. Hold outer C/V joint assembly with one hand. Grasp steering knuckle with other and rotate it out and to the rear of the vehicle, until outer C/V
joint clears hub and bearing assembly (Fig. 11).
Fig. 12
13. Remove driveshaft inner tripod joint from transaxle stub shaft. When removing driveshaft, do not pull on interconnecting shaft to remove inner
tripod joint from stub shaft. Removal in this manner will separate the spider assembly from the tripod joint housing. Grasp inner tripod joint (Fig.
12) and interconnecting shaft and pull on both pieces at the same time.
INSTALLATION
