Crossfire V6-3.2L VIN L (2004)
12. Remove the crankshaft main bearing shells (1) and thrust washers (2) from the crankcase.
13. Remove the crankshaft main bearing shells from the crankshaft main bearing journal caps.
INSTALLATION
Note: Clean all the journals with solvent and dry thoroughly before installing bearings.
1. Fit the upper main bearing shells (6) to the engine block's main journals.
2. Fit the thrust washers (7) into the engine block.
3. Coat the surface of bearings lightly with engine oil.
4. Position the crankshaft in the engine block.
5. Fit the lower main bearing shells (5) into the main bearing journal caps (4).
CAUTION: The crankshaft main bearing journal cap bolts M8X75 and M10X90 must always be replaced otherwise there is a risk of fracture.
6. Install the main bearing journal caps (4).
