Crossfire V6-3.2L VIN L (2004)
7. Remove the lower splash shield screws (1) and the splash shield.
8. Remove the engine mount lower bolt.
9. Remove the engine mount.
INSTALLATION
Note: The arrows on the engine mounts must be located in the retaining slots on the engine bracket.
1. Position the engine mount (3) on the crossmember.
2. Install the engine mount lower bolt (4). Tighten the bolt to 35 Nm (26 ft. lbs.).
Note: The recesses of the heat shield must be located in
the anti-twist slots of the engine bracket.
3. Lower the engine onto the engine mount. Install the heat shield (2) and the engine mount upper bolt (1).
4. Tighten the engine mount upper bolt (1) to 55 Nm (41 ft. lbs.).
