Crossfire V6-3.2L VIN L (2004)
Engine Oil Dip Stick - Dip Stick Tube: Service and Repair
REMOVAL
1. Remove the air cleaner housing.
2. Remove the bolt (1) in the cylinder head cover for the oil level indicator tube (2).
3. Remove the cable tie strap (3) holding the wire loom on the oil level indicator tube.
4. Pull up and remove the oil level indicator tube (2) from the engine.
INSTALLATION
1. Replace the oil level indicator tube seal and lubricate with engine oil.
Note: The oil level indicator tube must be fully seated or oil leaks can occur.
2. Position the oil level indicator tube (2) and install it in the crankcase.
3. Install the bolt (1) in the cylinder head cover and tighten to 10 Nm (89 in. lbs.).
4. Position the wire harness loom at the oil level indicator tube and fasten with new cable tie (3).
5. Install the air cleaner housing.
6. Start the engine and check for leaks.
