Crossfire V6-3.2L VIN L (2004)
Perform See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Powertrain Verification Test - Ver 3
4. FUEL PUMP RELAY OUTPUT CIRCUIT OPEN
Turn the ignition off.
Disconnect the Fuel Pump harness connector.
Note: Check connectors-Clean/repair as necessary.
Turn the ignition on.
With the DRB III, actuate the Fuel Pump Relay.
Using a 12-volt test light connected to ground, probe the Fuel Pump Relay
Output circuit at the Fuel Pump harness connector.
Does the test light illuminate brightly?
Yes>> Go To .
No>> Check for an open Fuel Pump fuse in the Relay Control Module. Repair the Fuel Pump Relay Output circuit for an open.
Perform See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Powertrain Verification Test - Ver 3
5. FUEL PUMP
Note: Check connectors - It is critical that the connector is free from any signs of corrosion or deformities. Clean/repair as necessary.
With the ignition on.
Using a 12-volt test light connected across the Fuel Pump harness connector.
With the DRB III, actuate the Fuel Pump Relay.
Does the test light illuminate brightly?
Yes>> Replace the Fuel Pump.
Perform See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Powertrain Verification Test - Ver 3
No>> Repair the fuel pump ground circuit for an open.
Perform See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Powertrain Verification Test - Ver 3
