Crossfire V6-3.2L VIN L (2004)
Integrated Control Relay Module: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Open the lid to the control module box.
3. Move the wires away to the side of the box to access the clip (1) that holds the relay control module in the control module box.
4. Push the clip (1) back away from the relay control module and lift the relay control module out of the control module box.
5. Remove all of the relay harness connectors from the relay control module.
INSTALLATION
1. Install the relay control module harness connectors to the relay control module.
2. Install the relay control module into the control module box, pushing the relay control module down until the clips snaps.
3. Install the control module box lid.
4. Connect the negative battery cable.
