Crossfire V6-3.2L VIN L (2004)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the camshaft position sensor harness connector (1).
3. Remove the retaining bolt (2) and the camshaft position sensor.
INSTALLATION
NOTE: Lubricate the camshaft position sensor O-ring with engine oil.
1. Position the camshaft position sensor on the cylinder head.
2. Install the retaining bolt (2) and tighten to 8 Nm (71 in. lbs.).
3. Connect the camshaft position sensor harness connector.
4. Connect the negative battery cable.
