Crossfire V6-3.2L VIN L (2004)
6. Remove the disc brake dust shield by removing the three hex bolts (1).
7. Remove the Wheel Speed Sensor (WSS) by removing the bolt and pulling the sensor straight out of the steering knuckle.
CAUTION: Do not use pneumatic tools to tighten the bolt on the special tool.
Note: Check the ball joint rubber boot for any wear or damage. Repair as necessary. The use of a allen wrench may be required to hold the stud
while turning the nut.
8. Remove the tie rod end from the steering knuckle by removing the nut from the tie rod joint stud. Using Special Tool C-3894-A Two Jaw Puller.
Slowly tighten the bolt until the tie rod end joint is pushed out of the steering knuckle.
CAUTION: Do not use pneumatic tools to tighten the bolt on the special tool.
Note: The use of a allen wrench may be required to hold the stud while turning the nut.
