Crossfire V6-3.2L VIN L (2004)
4. Check the lower control arm supporting ball joint. It should be possible to move the ball pivot without any play, jamming or creaking noises.
Move the ball pivot in all directions with a tube approximately 6 inch (150 mm) in length. Check the boot for any cracks or damage. If the boot is
leaking, replace supporting or follower joint.
5. Measure the steering knuckle, if necessary.
INSTALLATION
1. Install the steering knuckle and nut (1) to the upper ball joint stud. Tighten to 45 Nm (33 ft. lbs.).
2. Install the steering knuckle and nut to the lower ball joint stud (1). Tighten to 105 Nm (77 ft. lbs.).
