Crossfire V6-3.2L VIN L (2004)
Fluid Line/Hose: Service and Repair
TRANSMISSION COOLER LINES REMOVAL
Note: To service the front copper transmission cooler lines (5) the radiator must be removed.
1. Raise and support the vehicle.
2. Remove the lower splash shield.
3. Disconnect the fittings at either end of the line being serviced.
4. Remove the line retainers (1) and the cooler line(s) as necessary.
INSTALLATION
1. Position the cooler line(s) and loosely connect the fittings.
2. Install the retainers and bolts for the cooler line(s).
Note: Replace the copper washers if the banjo bolts are removed.
3. Tighten the cooler line fittings or banjo bolts to 20 Nm (15 ft. lbs.).
4. Tighten the transmission cooler line retaining bolts to 10 Nm (89 in. lbs.).
5. Lower the vehicle.
6. Install the radiator if removed.
7. Check the transmission fluid level.
