Crossfire V6-3.2L VIN L (2004)
Seals and Gaskets: Service and Repair
Outout Shaft Seal
OUTPUT SHAFT SEAL
REMOVAL
1. Remove the propeller shaft.
Move propeller shaft to the right and tie up.
2. Place the transmission in the PARK position before attempting to remove the output shaft nut.
3. Remove the output shaft nut holding the propeller shaft flange to the output shaft.
4. Remove the propeller shaft flange.
5. Remove the output shaft seal with suitable screw and slide hammer.
INSTALLATION
1. Position the new output shaft seal over the output shaft and against the transmission case (2).
2. Use Special Tool 8902A (1) to install the seal.
3. Install the propeller shaft flange onto the output shaft.
4. Place the transmission in the PARK position before attempting to tighten the output shaft nut.
5. Install a new output shaft nut. Tighten the output shaft nut to 120 Nm (88.5 ft. lbs.).
6. Stake the output shaft nut to the output shaft as follows.
a. Place the Special Tool 9078 (2) and Special Tool C-4171 onto the output shaft.
b. Rotate the Special Tool 9078 (2) until the alignment pin (3) engages the output shaft notch (4).
