Crossfire V6-3.2L VIN L (2004)
10. Remove the pinion flange seal (1) with a suitable prying tool.
INSTALLATION
1. Remove any burrs or nicks from the seal bore.
2. Drive in a new pinion flange seal (1) using Special Tool 9231 Drift and a mallet.
3. Install the pinion flange.
4. Install a new pinion shaft collared nut. Hold the pinion flange (1) with Special Tool C-3281 Flange Wrench (2). Tighten the nut to 180 Nm (133
ft. lbs.).
5. Check the resistance to rotation torque. If the resistance is less than the previously recorded value, tighten the pinion in 5 Nm (44 inch lbs.)
increments until the resistance amount is reached.
6. Connect the halfshafts to the differential connecting flanges.
7. Install the propeller shaft.
8. Install the muffler.
9. Fill the differential housing to specification.
