Crossfire SRT-6 V6-3.2L SC VIN N (2005)
15. Disconnect the hydraulic lines (4) from the cylinder (2).
16. Remove the travel sensors from the rear bow cylinder (left side only).
17. Remove the upper and lower retainers (1 and 3) and remove the cylinder from the top frame assembly (right side shown, left side similar).
REMOVAL - CYLINDER TRAVEL SENSOR
NOTE: If a main cylinder or rear bow cylinder travel sensor is faulty, all of the main and rear bow cylinder travel sensors must be replaced.
1. Remove the plastic tie wrap (3) from the hydraulic cylinder.
2. Rotate the hydraulic line (1) on the hydraulic cylinder in order to gain access to the travel sensor.
NOTE: The travel sensor is retained by a pressed fit. To remove the travel sensor, grasp the sensor and gently pry the sensor from the hydraulic
cylinder housing.
3. Remove the travel sensor (2) from the hydraulic cylinder.
INSTALLATION
INSTALLATION - TONNEAU COVER CYLINDER
