Crossfire SRT-6 V6-3.2L SC VIN N (2005)
POSSIBLE CAUSES
-
Left seat back/cushion heater element
-
Left heated seat output circuit open
-
Left heated seat ground circuit open
-
Heated seat module
DIAGNOSTIC TEST
1. TEST THE LEFT HEATED SEAT
Turn the ignition off.
Disconnect the Heated Seat Module harness connector.
NOTE: Check connector - Clean/repair as necessary.
Connect a fused jumper wire from B(+) to cavity 3 (LHD) of the Heated Seat Module harness connector.
Q: With the jumper wire connected, does the Left Heated Seat warm up?
YES: Replace the Heated Seat Module. Perform BODY VERIFICATION TEST. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Go to 2
2. MEASURE LEFT HEATED SEAT OUTPUT CIRCUIT RESISTANCE
