Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Power Door Lock Switch: Service and Repair
Driver Door Lock Switch
REMOVAL
WARNING: REFER TO RESTRAINTS BEFORE ATTEMPTING ANY DOOR, SEAT, STEERING WHEEL, STEERING COLUMN, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect the negative battery cable.
2. Remove the door interior trim panel.
3. Carefully peel back the door watershield enough to expose the driver door lock switch.
4. Release the locking tab (1) attaching the driver door lock switch to the door latch assembly.
5. Disconnect the pneumatic supply line (2) from the door lock actuator.
6. Disconnect the remaining door harness connectors, and remove the driver door lock switch.
INSTALLATION
NOTE: Ensure the harness is routed and secured in its original position to avoid potential interference with moving parts.
1. Install the door harness assembly into the door.
2. Install the driver door lock switch into the door latch assembly (1).
3. Install the door watershield.
4. Install the door interior trim panel.
5. Connect the negative battery cable.
