Crossfire SRT-6 V6-3.2L SC VIN N (2005)
1. Inspect the seating and condition of the rubber grommets and replace if necessary.
CAUTION: Use caution when re-connecting hydraulic lines. Refer to markings for proper installation. If necessary, trace the line routing to the
corresponding wheel.
2. Install the brake lines (1-6). Pay very close attention to the locations when installing the hydraulic lines. DO NOT cross thread.
^
Right rear wheel (1)
^
Master cylinder front (2)
^
Right front wheel (3)
^
Left front wheel (4)
^
Left rear wheel (5)
^
Master cylinder rear (6)
3. Connect the hydraulic control unit harness connector (1) to the CAB.
4. Bleed the brake system.
5. Connect the DRBIII and read any DTCs, then clear any applicable codes.
