Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Brake Master Cylinder: Service and Repair
Master Cylinder - Removal and Installation
LHD
BRAKE MASTER CYLINDER
REMOVAL - LHD
CAUTION: Do not spill brake fluid on any painted surfaces. Brake fluid can damage paint.
1. Disconnect the brake fluid level sensor harness connector (2) from the reservoir (1).
2. Disconnect the master cylinder brake fluid pressure sensor (4) harness connectors.
3. Remove brake lines (3) from master cylinder (5).
4. Remove the nuts that attach the master cylinder (5) to the booster (6) studs.
WARNING: DO NOT TILT THE MASTER BRAKE CYLINDER WHEN REMOVING FROM THE BRAKE BOOSTER. IF TILTED,
THE BRAKE ROD CAN BE DISCONNECTED FROM THE MASTER CYLINDER.
5. Remove the master cylinder (5) from the booster (6).
6. Remove the O-ring (7) from the master cylinder (5).
INSTALLATION
