Crossfire SRT-6 V6-3.2L SC VIN N (2005)
6. Remove the booster retaining nuts (2) that attach the booster (1) to the dash panel.
7. Slide booster (1) forward, tilt the booster upward slightly, then remove the booster from the engine compartment.
INSTALLATION - RHD
1. Align and position the booster (1) on the dash panel.
2. Lubricate the pedal pin with Mopar multi-mileage grease.
3. Install the booster retaining nuts (2). Tighten to 39 Nm (29 ft. lbs.).
4. Align the brake booster (1) push rod to the holes on the brake pedal (3) then install the brake rod pin (2) and retaining clip (4) to the brake pedal
(3).
5. Check the condition of the grommet that secures the check valve (1) in the booster. Replace the grommet if it is worn or damaged. Install the
