Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Note: The connecting rod bearing shell with the oil drilling (2) must be installed in the connecting rod, otherwise the connecting rod bearings will
not be lubricated. The anti-twist locks of the connecting rod bearing shells must be located in the slots (1) of the connecting rods and the
connecting rod bearing caps.
7. Align the connecting rod caps with the marks (1).
8. Install the connecting rod bolts.
9. Tighten the connecting rod bolts in three stages.
^
Stage one, 5 Nm (44 inch lbs.)
^
Stage two, 25 Nm (18 ft. lbs.)
^
Stage three, rotate bolts 90° clockwise.
10. Test the engine for ease of rotation.
11. Install the timing chain.
