Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Crankshaft Main Bearing: Removal and Replacement
CRANKSHAFT AND MAIN BEARINGS
REMOVAL
1. Remove the upper oil pan.
2. Remove the oil pump.
3. Remove the rear crankshaft radial seal.
4. Remove the timing chain.
Note: When rotating the crankshaft, ensure that the connecting rods are not twisted.
Note: Mark the connecting rod and the connecting rod bearing cap (1) on one side next to each other for this step.
5. Remove the connecting rod bolts (1).
Note: Do not dislodge the connecting rod bearings from the connecting rods.
