Crossfire SRT-6 V6-3.2L SC VIN N (2005)
6. Perform work on a suitable surface to prevent dam age to parts.
7. Keep the piston pins matched to the pistons.
8. Remove the snap rings from the pistons (2).
9. Press out the piston pins (1).
10. Remove the piston from the connecting rod (3).
11. Inspect all parts to be reused for damage. Replace as required.
INSPECTION
CONNECTING ROD
1. Check the connecting rods for any twisting or bending.
2. Check the condition of the large end. Use an oil stone to remove any nicks and burrs.
3. Check the condition of the pin bore in the small end of the connecting rod. Use an oil stone to remove all nicks and burrs.
PISTON PIN
1. Inspect for free rotation of the wrist pin in the piston.
PISTON
1. Inspect all piston surfaces for nicks and scuffs.
2. Inspect piston and ring grooves for wear.
INSTALLATION