Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Headlamp Motor: Testing and Inspection
Headlamp Leveling System
NOTE: The battery must be completely charged (12v) prior to testing. It may also be necessary to install a battery charger on the vehicles electrical
system when performing this test. Refer to the Electrical, Battery System for detailed information.
1. Rotate the headlamp switch (low beam) to the ON position.
2. Disconnect the headlamp leveling motor harness connector.
3. Check PIN #3 for battery voltage. If not present, trace the circuit until the open or short is found.
4. Check PIN #1 for ground. If not present, trace the circuit until the open or short is found.
5. Check PIN #2 for headlamp leveling sense voltage (2.83 - 5.00v). If not present, trace circuit until open or short is found.
6. If no open or short is found and the headlamp leveling system is still inoperative, replace the headlamp leveling motor.
7. If testing is still inconclusive, refer to Headlamp Leveling Switch testing for further tests.
