Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Combination Switch: Description and Operation
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG,
OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT
DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO
MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS
THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.
The Multifunction Switch and control circuitry (3) is concealed below the steering column shrouds and will operate when the ignition switch is turned to
the ACC or ON/RUN positions. Fuse 32 in the Underhood Accessory Fuse Block protect the circuitry of the Wiper System and the vehicle.
The Wiper System in addition to HI (1) and LO (2) speeds, has an intermittent delay (3) mode. The wipers will return to the park position when the
wiper portion of the switch is rotated to the OFF position. A mist function can be operated by briefly pressing the end of the Multifunction Switch lever
inward. In addition to operating the Wiper System, the Multifunction Switch also operates high beam/flash to pass and turn signals.
The Multifunction Switch cannot be adjusted, or repaired. If faulty, worn, or damaged, the entire unit must be replaced.
