Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Alignment: Service and Repair
Chassis Alignment Inspection
STANDARD PROCEDURE - CHASSIS ALIGNMENT INSPECTION
1. Observe the general information on chassis alignment inspection.
2. Drive the vehicle onto an electronic measuring system.
3. Unlock the turntables and the sliding platforms.
4. Install a brake pedal winch on the brake pedal.
5. Attach the wheel sensors.
6. Perform the initial measurement process.
7. Inspect the vehicle level at the front and the rear axles and adjust if necessary.
8. Inspect the vehicle level at the front and the rear axles with an electronic inclinometer and adjust if necessary.
9. Inspect and adjust the rear axle toe.
10. Inspect and adjust the front axle camber and caster.
11. Inspect the rear axle camber.
12. Inspect and adjust the front axle toe.
13. Perform the final measurement of the vehicle.
14. Detach the sensors.
15. Remove the brake pedal winch.
16. Carefully drive the vehicle off the measuring system.
17. Lock the turntables.
