Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Brake Fluid: Service and Repair
STANDARD PROCEDURE
MASTER CYLINDER FLUID LEVEL
Always clean the master cylinder reservoir and cap before adding fluid. This will prevent dirt from falling in the reservoir and contaminating the brake
fluid.
The reservoir (2) has a MIN and a MAX mark (1) on the side. Always fill to the MAX mark.
SPECIFICATIONS
BRAKE FLUID
CAUTION: Never use reclaimed brake fluid or fluid from a container which has been left open. An open container of brake fluid will absorb
moisture from the air and contaminate the fluid.
CAUTION: Never use any type of a petroleum-based fluid in the brake hydraulic system. Use of such type fluids will result in seal damage of the
vehicle brake hydraulic system causing a failure of the vehicle brake system. Petroleum based fluids would be items such as engine oil, transmission
fluid, power steering fluid, etc.
Use brake fluid approved to MB 331.0, such as Mopar part number 0454925AC, or a DOT 4 brake fluid with: minimum dry boiling point (ERBP)
500°F, minimum wet boiling point (WERBP) 356°F, maximum viscosity 1500 mm2/s, conforming to FMVSS 116 and ISO 4925.
