Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification
Test - Ver 2.
No >> Repair the Ground circuit for an open. Perform the POWERTRAIN VERIFICATION TEST - VER 2 See: Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test -
Ver 2.
6. CHARGE AIR COOLER CIRCULATION PUMP DRIVER CIRCUIT OPEN
Turn the ignition off. Disconnect the Pulse Module E harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Charge Air Cooler Circulation Pump Driver circuit from the Pulse Module E harness connector to the Fuse 13 input
cavity.
Is the resistance below 5.0 ohms?
Yes >> Go To 7
No >> Repair the Charge Air Cooler Circulation Pump Driver circuit for an open. Perform the POWERTRAIN VERIFICATION TEST - VER
2 See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification
Tests/Powertrain Verification Test - Ver 2.
7. CHARGE AIR COOLER CIRCULATION PUMP DRIVER CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the Charge Air Cooler Circulation Pump Driver circuit at the Pulse Module E harness connector.
Is the resistance above 100 kohms?
Yes >> Replace the Pulse Module. Perform the POWERTRAIN VERIFICATION TEST - VER 2 See: Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test -
Ver 2.
No >> Repair the Charge Air Cooler Circulation Pump Driver circuit for a short to ground. Perform the POWERTRAIN VERIFICATION
