Crossfire SRT-6 V6-3.2L SC VIN N (2005)
1. Position the ignition coil (3) on the cylinder head cover.
2. Install the ignition coil retaining bolt (2). Tighten the bolt to 8 N.m (71 in. lbs.).
3. Connect the ignition coil wire harness connector (1) to the coil pack.
NOTE: When installing the spark plug cables, route the cables correctly. Failure to route the cables properly can cause improper spark plug phase
shift.
4. Install the spark plug cables to the appropriate coil tower (A & B) (coil side).
5. Install the spark plug cables to the appropriate spark plug location (G & K) (plug side).
NOTE:
-
Refer to the reference pad cast into the cylinder head cover to identify proper spark plug/spark plug cable orientation.
-
When installing spark plug cables, insure a positive connection is made. A snap should be felt when a good connection is made between
the spark plug cable and the spark plug.
