Crossfire SRT-6 V6-3.2L SC VIN N (2005)
-
Ground circuit open.
DIAGNOSTIC TEST
1. MEASURE THE VOLTAGE OF THE DLC POWER CIRCUIT
NOTE: If the LEDs do not light or no sound is emitted at start up, check for loose cable connections or a bad cable. Check the vehicle battery
voltage (data link 16-way connector cavity 16). A minimum of 11 volts is required to adequately power the DRB III(R). Check for a proper
ground at DLC cavity 4. If all connections. are proper between the DRB III(R) and the vehicle or other devices and the vehicle battery is fully
charged, an inoperative DRB III(R) may be the result of a faulty cable.
Turn the ignition off.
Measure the voltage of the Fused B(+) circuit at cavity 16 of the Data Link Connector.
Q: Is the voltage above 11 volts?
YES: Go to 2
NO: System voltage must be above 11 volts. Check Fuse 14 in the Underhood Accessory Fuse Block. Repair the voltage concern as necessary.
Perform BODY VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
2. MEASURE THE RESISTANCE OF THE DLC GROUND CIRCUIT
Measure the resistance between ground the Ground circuit at cavity 4 of the Data Link Connector.
Q: Is the resistance below 5.0 ohms?
YES: Inspect the DRB III(R) for a possible malfunction. Perform BODY VERIFICATION TEST. See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Repair the DLC Ground circuit for an open. Perform BODY VERIFICATION TEST. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
