Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Control Module: Service and Repair
REMOVAL
1. Un-snap and remove the carpet floor mat.
2. Fold back the carpeting in the passenger footwell to expose the foam insulation panel.
3. Remove the foam insulation panel.
NOTE: It is not necessary to remove the electrical connectors to rotate the base plate in the passenger footwell.
4. Remove the three plastic retaining nuts (1) from the floor panel studs.
5. Lift the base plate and rotate the top of the base plate toward the rear of the vehicle to expose the TCM.
