Crossfire SRT-6 V6-3.2L SC VIN N (2005)
COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, FRONT IMPACT SENSOR, SIDE IMPACT SENSOR, SIDE CURTAIN AIRBAG, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND)
CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS
OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE
PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Verify the negative battery cable (2) is disconnected before proceeding. Wait two minutes for the system capacitor to discharge before further
service.
2. Position the side impact airbag to the door.
3. Install new mounting rivets (1) for the side impact airbag.
NOTE: Use only the proper rivets when reinstalling the side impact airbag.
4. Connect the squib connector (2).
CAUTION: Use caution when connecting the squib harness connector to the side impact airbag receptacle. Improper assembly of these
connectors can result in damage to the airbag circuits or connector insulators.
5. Install the door trim panel.
6. Install the ignition key.
7. Do not reconnect the negative battery cable at this time. Perform the Supplemental Restraint System verification test procedure after servicing any
Supplemental Restraint System component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints Verification Test
