Crossfire SRT-6 V6-3.2L SC VIN N (2005)
INSTALLATION
1. Carefully position the occupant restraint controller on the mount that is welded onto the top of the floor panel transmission tunnel. The arrow on
the housing must point toward the front of the vehicle.
2. Install and tighten the screws (1) that secure the occupant restraint controller to the mount. Observe the ground lead mounting location on the left
rear screw. Tighten the screws to 11 N.m (97 in. lbs.).
3. Connect the occupant restraint controller harness connector (2).
4. Install the center console.
5. Do not reconnect the negative battery cable at this time. The new ORC module must be programmed, perform the Supplemental Restraint System
verification test procedure after servicing any Supplemental Restraint System component. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
