Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Seat Belt Tensioner: Service and Repair
REMOVAL
WARNING:
-
DURING AND FOLLOWING ANY SEAT BELT OR CHILD RESTRAINT ANCHOR SERVICE, CAREFULLY INSPECT ALL SEAT
BELTS, BUCKLES, MOUNTING HARDWARE, RETRACTORS, TETHER STRAPS, AND ANCHORS FOR PROPER
INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY
BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS. REPLACE ANY BELT THAT HAS A DAMAGED OR
INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A BENT OR DAMAGED LATCH PLATE OR
ANCHOR PLATE. REPLACE ANY CHILD RESTRAINT ANCHOR OR THE UNIT TO WHICH THE ANCHOR IS INTEGRAL
THAT HAS BEEN BENT OR DAMAGED. NEVER ATTEMPT TO REPAIR A SEAT BELT OR CHILD RESTRAINT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT AND CHILD RESTRAINT COMPONENTS WITH THE CORRECT,
NEW AND UNUSED REPLACEMENT PARTS LISTED IN THE DAIMLERCHRYSLER MOPAR PARTS CATALOG.
-
NEVER DISASSEMBLE THE SEAT BELT TENSIONERS.
CAUTION: Never attempt to eliminate noises by lubricating with oil or grease.
1. Before attempting any service procedure refer to the warnings.
2. Move the seat to the full forward position.
3. Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.
4. Remove the plastic bolt cover from the seat.
5. Remove the bolt (1) on the belt end attaching it to the seat.
