Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Brake Fluid Level Sensor/Switch: Service and Repair
BRAKE FLUID LEVEL SENSOR
REMOVAL
CAUTION: Do not spill brake fluid on any painted surfaces. Brake fluid can damage painted surfaces.
Note: The brake fluid level sensor cannot be replaced by itself. You must replace the fluid reservoir.
1. Disconnect the brake fluid level sensor harness connector.
2. Remove the screw attaching the fluid reservoir to the master cylinder.
3. Remove the fluid reservoir from the master cylinder.
INSTALLATION
1. Install the fluid reservoir to the master cylinder.
2. Install the screw (1) attaching the fluid reservoir to the master cylinder.
3. Connect the brake fluid level sensor harness connector.
4. Fill the reservoir with MOPAR brake fluid to the proper level.
5. Bleed the braking system.
