Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Coolant Level Sensor: Service and Repair
COOLANT LEVEL SENSOR
REMOVAL
1. Partially drain the cooling system.
2. Disconnect the coolant level sensor harness connector (2).
3. Depress the locking tabs and pull the coolant level sensor (1) from the coolant recovery reservoir.
INSTALLATION
1. Lubricate the new coolant level sensor O-ring with coolant.
2. Push the coolant level sensor (1) into the coolant recovery reservoir until it snaps into place.
3. Connect the coolant level sensor harness connector (2).
4. Refill the cooling system.
5. Start the engine and check for coolant leaks.
6. Recheck the coolant level and adjust as necessary.
