Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Tie Rod End: Service and Repair
TIE ROD END
REMOVAL
1. Loosen the tie rod end jam nut (1).
2. Remove nut from the tie rod end at the steering knuckle.
3. Using Special Tool C-3894-A (2) two jaw puller remove the tie rod end (1) from the steering knuckle.
4. Unscrew the tie rod end from the drag link.
INSTALLATION
1. Clean the tapered surfaces, and remove any grease or debris from the tie rod end.
2. Thread the tie rod end onto the drag link.
3. Install the tie rod end to the steering knuckle.
4. Install the attaching nut on the tie rod end. Tighten to 50 Nm (37 ft. lbs.).
5. Thread the jam nut down far enough to hold the tie rod end in place. Do not tighten the jam nut.
6. Adjust the front toe setting on the vehicle.