Crossfire SRT-6 V6-3.2L SC VIN N (2005)
6. Install the front spring (1).
7. Lower the vehicle and check vehicle alignment.
8. Install the front wheel and tire assembly.
Upper Control Arm
FRONT UPPER CONTROL ARM
REMOVAL
Note: If working on the right side remove the air cleaner housing to access the upper control arm bolt and nut. To remove the upper control arm the
shock absorber must remain installed.
1. Remove the front wheel and tire assembly.
2. Wire tie the steering knuckle to the shock absorber (arrow). This is to hold the steering knuckle from falling away from the vehicle.
3. Remove the ball joint nut (3) from the upper control arm (2).
CAUTION: Do not subject the brake hose and any electrical cables to any tension. Do not use pneumatic tools to tighten the bolt on the tool.
4. Using Special Tool 9168 Ball Joint Puller, press the upper ball joint out of the steering knuckle.
5. Remove the upper control arm (2) from the body by removing the nut and bolt (1) from the inside of the engine compartment on the shock tower.
INSTALLATION
WARNING: TIGHTEN ALL NUTS AND BOLTS WITH THE VEHICLE AT NORMAL RIDE HEIGHT.
