Crossfire SRT-6 V6-3.2L SC VIN N (2005)
11. Remove the steering knuckle from the upper control arm by removing the nut (1) from the upper ball joint stud.
12. Using Special Tool 9168 Ball Joint Puller slowly tighten the bolt until the upper ball joint is pushed out of the steering knuckle.
CHECKING
1. Check the lower control arm supporting ball joint by performing the following:
2. Remove the nuts (1) from the lower control arm supporting ball joint.
3. Using Special Tool 9168 Ball Joint Puller (2) press out the lower control arm supporting ball joint (1).
