Crossfire SRT-6 V6-3.2L SC VIN N (2005)
5. Remove the front wheel hub dust cap (4).
6. Loosen the hub nut bolt then remove the hub nut (3) and then remove the tapered roller bearing (2).
7. Remove the front wheel hub (1) from the spindle.
INSPECTING HUB AND BEARINGS
1. Remove the bolts (1) and inspect the front disc brake dust shield and replace if necessary.
Note: Discoloration may be caused by generated heat due to incorrect bearing end play settings.
CAUTION: Only replace the tapered roller bearing and bearing races in pairs.
2. Inspect the spindle for any discoloration or wear on the bearing seats or the contact surface of the radial seal ring. Replace if necessary.
