Crossfire SRT-6 V6-3.2L SC VIN N (2005)
3.
Disconnect the oxygen sensor harness connectors and reposition the oxygen sensor harness out of the way (Fig. 5).
4.
Remove the oxygen sensor heat shield bolts and the heat shield (Fig. 5).
5.
Remove the bolt and loosen the screw securing the 13 pin connector heat shield in the right front corner of the transmission assembly (Fig. 4).
Remove the heat shield and set it aside.
6.
Disconnect the 13-pin connector plug by turning the bayonet lock of the connector guide bushing counter clockwise (Fig. 1).
7.
Place a suitable drain pan under the connector guide bushing to catch transmission fluid that may drain during the next step.
8.
Using a 7 mm socket, loosen the bronze bolt securing the connector guide bushing. The bronze bolt is located in the center of the connector guide
bushing (Fig. 2).
9.
Remove the connector guide bushing from the transmission.
10.
If there is a locator tab present, using side cutter pliers, remove the locator tab on the connector guide bushing (Fig. 3).
11.
Using transmission fluid, lubricate and place 1 p/n 52108323AB 0-ring and 1 p/n 52108324AB 0-ring on the connector guide bushing.
NOTE:
The 0-rings are two different sizes. Be careful to place the new 0-rings in the correct location.
12.
Install the connector guide bushing in the transmission.
13.
Tighten the bronze bolt securing the guide bushing in place. Tighten the bronze bolt to 2.5 N.m +/- 0.2 N.m (22 in. lbs +/- 2 in.lbs.) (Fig. 2).
14.
Connect the 13-pin plug connector. Secure the connector by turning the bayonet lock of the connector guide bushing clockwise.
15.
Position the 13 pin connector heat shield and install the bolt and screw securing the heat shield in the right front corner of the transmission
assembly (Fig. 4).
16.
Position the oxygen sensor heat shield onto the transmission housing and install the screw and bolt which secure the shield in place.(Fig. 5).
17.
Connect the oxygen sensor harness connectors and secure the wiring harness in the oxygen sensor heat shield (Fig. 5).
18.
Clean the area of any residual transmission fluid which may be present as a result of the repair.
19.
Lower the vehicle.
20.
Connect the negative battery cable.
NOTE:
Be sure to use the correct transmission fluid, Mopar p/n 05127382AA.
21.
Check the transmission fluid and adjust as necessary. Refer to the service information available in TechCONNECT. Reference: Service Info, 21 -
Transmission/Transaxle/Automatic - NAG1/Fluid - Standard Procedure.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
