Crossfire SRT-6 V6-3.2L SC VIN N (2005)
2. Install the C/V joint assembly onto the axle halfshaft by using a soft-faced hammer and tapping the end of the stub axle until the C/V joint is fully
seated on the axle halfshaft.
Note: The C/V joint assembly must be installed on axle halfshaft until the C/V joint assembly is seated against the circlip on the halfshaft.
Note: Do not use any other type of grease other than what is supplied in the C/V boot service package.
3. Pack approximately 1/2 the amount of grease provided in the C/V boot service package into the outer C/V joint cavity.
4. Pack the remaining amount of grease into the C/V boot.
Note: The C/V boot must be positioned on the axle halfshaft so the raised bead on the inside of the C/V boot is in the groove on the axle halfshaft.
5. Install the C/V boot outer end into the sealing groove (1) of the C/V joint housing.
