Crossfire SRT-6 V6-3.2L SC VIN N (2005)
7. Pack approximately 1/2 the amount of grease provided in the C/V boot service package into the outer C/V joint cavity.
8. Pack the remaining amount of grease into the C/V boot.
Note: The C/V boot must be positioned on the axle halfshaft so the raised bead on the inside of the C/V boot is in the groove on the axle halfshaft.
9. Install the C/V boot outer end into the sealing groove (1) of the C/V joint housing.
10. Install the C/V boot inner end into the sealing groove of the axle halfshaft.
11. Position the inner C/V boot retaining clamp (1) and the outer C/V boot retaining clamp (2) into the sealing grooves on the C/V boot.
