Crossfire SRT-6 V6-3.2L SC VIN N (2005)
Control Module: Testing and Inspection
The quick learn procedure requires the use of the DRB III(R) scan tool. Navigate to Transmission, Transmission Control (TCM), Miscellaneous
Functions, and Reset Adapt, Shift Quality. Follow the onscreen instructions.
This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn
procedure should be performed if any of the following procedures are performed:
-
Transmission Assembly Replacement
-
Transmission Control Module Replacement
-
Solenoid Pack Replacement
-
Clutch Plate and/or Seal Replacement
-
Valve Body Replacement or Recondition
To perform the Quick Learn Procedure, the following conditions must be met:
-
The brakes must be applied
-
The engine speed must be above 500 rpm
-
The shift lever position must stay in Park until prompted to shift to Drive
-
The shift lever position must stay in Drive after the Shift to Drive prompt until the DRB III(R) indicates the procedure is complete
-
The calculated oil temperature must be above 15.6 degrees C (60 degrees F) and below 93.3 degrees C (200 degrees F)
