Fifth Avenue V6-231 3.8L VIN L FI (1992)
Suspension Control Module: Service and Repair
Fig. 49 Removing Control Module (ASCM) & Relay
NOTE: Open trunk, door(s) or disconnect battery ground cable before raising vehicle. Rear air springs must be deflated before being removed from
vehicle.
1. Disconnect battery ground cable.
2. Remove right side trunk trim panel.
3. Disconnect control module and relay electrical connectors.
4. Remove control module mounting screws, then the control module.
5. Reverse procedure to install, noting the following:
a. Install relay on control module mounting bracket, if required.
b. Torque control module mounting screws to 19-29 lb-in.
