Fifth Avenue V8-318 5.2L VIN R 4-bbl (1986)
Seat Back: All Technical Service Bulletins
Seat Back - Rattle Noise
Models
1985 & 1986 Chrysler Fifth Avenue, Plymouth Gran Fury & Dodge Diplomat With 60-40 or Bucket Seats
Subject
Seat Back Rattle
Index
BODY
Date
November 25, 1985
No..
23-26-85
P-4364-C
SYMPTOM/CONDITION
Seat back rattle on subject model vehicles may be the result of an improperly installed or deformed bushing on the seat back. To remedy this condition,
use the following procedure.
PARTS REQUIRED
1 Flip Lock Tool (includes package of 10 bushings)* Miller #C-4985
1 Bushing Per Seat Back (available from Parts
PN 6033020
Supply)
REPAIR PROCEDURE
The repair will consist of replacing the seat back bushings.
1.
Raise vehicle.
2.
Remove seat attaching nuts.
3.
Lower vehicle.
4.
Disconnect wiring to power seat, if so equipped.
5.
On 60-40 drivers seat, remove inner seat belt mounting bolt.
6.
Remove seat from vehicle and place upside down on a clean surface.
7.
Remove mounting nuts from bezel on power seat switch control and remove bezel, if so equipped.
8.
Remove outer hinge arm cover.
9.
Remove recliner cable mounting bracket screw and disconnect cable from recliner, if so equipped.
*Tool must be used for proper installation of bushing.
10.
Detrim seat cushion enough to expose hinge arm mounting bolts.
11.
Remove bolts and carefully separate seat back from cushion.
12.
Remove seat back trim enough to expose bushing on inner side.
