Laser L4-135 2.2L SOHC Turbo VIN E FI (1984)
For 2.2L Turbo Models
1. Hold inner joint assembly at housing while aligning and guiding the inner joint spline into the intermediate shaft assembly.
For 2.2L Turbo Models
Be sure that the rubber washer seal is in place on the right inner CV joint.
Caution: When installing an "A.C.I." shaft (see Application and ID if you are unsure which manufacturer you have), be sure that the tripod is engaged
in the housing and the is not twisted.
Caution: Seal/Wear Sleeve Lubrication: During any service procedures where knuckle and driveshaft are separated, thoroughly clean both seal and
wear sleeve with suitable solvent (solvent must not touch boot) and relubricate both components prior to reinstalling driveshaft. Lubricate wear sleeve
and seal with MOPAR Multi-Purpose Lubricant, Part Number 4318063 or equivalent. Apply on the full circumference of the Wear Sleeve a bead of
lubricant that is 6 mm (1/4 in.) wide to seal contact area as shown. Fill lip to housing cavity on Seal, complete circumference, and "wet" seal lip with
lubricant as shown.
