LeBaron L4-135 2.2L VIN B 2-bbl (1982)
Fuel Pump Overlay HarnessRouting Through BodyFigure 3-A
3.
Install sending unit jumper harness, PN 4331122, by feeding the black 5-way connector through the vacated grommet hole. Make sure
grommet on new harness is fully seated in body hole (Figure 3-A).
FIGURE 3-A - FUEL PUMP OVERLAY HARNESS ROUTING THROUGH BODY
4.
Route the overlay harness, PN 4368596 or 4368597, along the left side rear wheel housing and along main body harness, working toward
instrument panel, using the retainer clips indicated in Figure 3-A. Tape overlay harness to main harness (Figure 3-A).
CAUTION:
MAKE SURE THAT THE OVERLAY HARNESS WILL NOT BE PINCHED FROM THE SCUFF PLATE
FASTENING SCREWS DURING REINSTALLATION.
5.
Finish routing the overlay harness along the deck lid side of the V support and insert the locator clip in the vocated locator hole (Figure 3-A).