LeBaron L4-135 2.2L VIN B 2-bbl (1982)
FIGURE 2-A - INSTRUMENT PANEL WIRING
11.
Allow the black 2-way connector of harness, PN 4368642, to hang down along the left side cowl for mating with the body overlay harness
(Figure 2-A).
12.
Connect the overlay harness, PN 4368642, ground terminal to the instrument panel ground stud (located behind the fuse block) and secure
with the supplied nut, PN 6023201 (Figure 2-A).
FIGURE 2-B - TYPICAL CONTROL MODULE MOUNTING
13.
Connect the control module, PN 5226640, to the natural colored 8-way connector on overlay harness, PN 4368642. Secure the module to the
instrument panel main wiring harness with a tie wrap, PN 6015756, close to the bulkhead connector (Figure 2-B).
14.
Reinstall engine side of bulkhead connector and torque to 40 inch pounds. Reinstall clutch or shift cable bracket (if so equipped).
C.
Body Harnesses PN 4331122, 4368596 (1981 Only) and 4368597 (1982 Only)
1.
Remove the left side sill scuff plate and rear seat upper and lower cushions. Remove the spare tire.
2.
The existing wiring going through floor grommet to tank will not be used. Remove existing harness at floor grommet and locator clip on V
support. Spot tape harness to V support and to floor panel so wiring does not rattle. The old harness will be covered by the rear seat cushion
when reassembled.
