Lebaron Convertible L4-135 2.2L SOHC Turbo VIN E FI (1985)
10.
Attach supplied MAP sensor, PN 5227492 for Turbo or 5227491 for EFI, to bracket, PN 5227493, using supplied screws, PN 152791, and nuts,
PN 9419784 (Figure 1).
11.
Attach MAP sensor and bracket assembled in Step 10 to shock tower with supplied screw, PN 6029513. Screw attach bracket through hole drilled
in dimple in Step 9. Location tab of bracket fits in lower hole drilled in Step 9. MAP sensor connections should be on the side facing the ground
(Figure 1).
12.
Install logic module.
13.
Feed jumper wires through 1/2" hole from passenger compartment out to engine compartment. Seat grommet of wiring assembly, PN 4368706, in
1/2" hole in dash panel. Place wiring in passenger compartment under carpet pad.
14.
Attach wiring assembly, PN 4358706, to brake line on dash panel with two cable ties, PN 6015756. Fasten wiring assembly with third cable tie to
vacuum harness near passenger side shock tower (Figure 1).
