Lebaron Convertible L4-135 2.2L SOHC Turbo VIN E FI (1985)
8.
Push pivots down into plenum chamber, pull motor out until it clears mounting studs and then as far to the driver's side (outboard) as it will go. Pull
right pivot and link out through opening, then shift motor to opposite side (inboard) of opening and remove motor, left link and pivot.
9.
Clamp motor crank in a vise and remove nut from end of motor shaft. Do not rotate motor output shaft from park position.
INSTALLATION
1.
Assemble linkage to motor. Make sure crank fits over "D" slot on motor shaft. Torque mounting nut to 95 in lb (11 Nm). Be sure motor is still in
park position before assembling to linkage. If not, temporarily connect motor wiring and operate switch to position motor in park before
assembling linkage.
2.
Place left pivot and link into plenum chamber and slide all the way to the left (outboard) until motor clears studs and crank is behind sheet metal.
Push right pivot and link through opening. Move assembly right and position motor on studs.
3.
Install 3 motor mounting nuts and torque to 55 in lb (6 Nm).
4.
Position pivots and install pivot screws. Torque to 55 in lb (6 Nm).
5.
Connect wiring to motor.
6.
Install motor cover and torque screws to 35 in lb (4 Nm).
7.
On "G" body, attach reservoir hose to "T" connector through hole in cowl screen.
8.
On "G" body, use plastic fasteners to install cowl screen.
9.
Install arm and blade assemblies. Connect arm washer hoses to "T" connector.
Models L/M, Z
REMOVAL
